Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Don't wait up for the sequel.
I'm sure some of you are wondering if the drum roller shafts and idler wheel shaft should be lubricated. Replace the idler pulley, washer to the inside of the shaft/front of the dryer.
Cons
This seller is not honest about the attributes of the products they're selling. Just check the pn before u order. Attempted to contact supplier. Only it don't.
The belt is too short. Lots of people love this kit, but for me the belt was useless.
Highlights
Quality
Product arrived on time as stated and good quality overall satisfied with product
With the removal of the old clips youre not concerned about overstretching because theyll be replaced
Im quite sure these were not knockoffs and you can tell they are quality parts
I first had to order the vent kit with the dryer
Competitiveness
Definitely much heavier than the off brand
I did use a 18v impact with a 1434 magnetic nutdriver which saved me a few minutes and a lot of wristache
Ive seen it all and been promised the world
Overview
- How are reviewers describing this item?
new, fit, great, good and easy. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 1,840 reviews as of our last analysis date on Dec 5 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
You will need to completely disassemble the dryer
Posted by a reviewer on Amazon
Just dont get overly enthusiastic and overstretch them
Posted by a reviewer on Amazon
These triangle clips are retention clips that remain 34captive34 in channels so if theyre stretched too much and develop an elongated memory they may escape out of the channels and off the shafts
Posted by a reviewer on Amazon
If an overstretched outer clip slides off there is nothing that acts as a stop to prevent the drum support roller or idler pulley wheel from falling off its shaft
Posted by a reviewer on Amazon
I choose not to because oilgrease is a lintdebris magnet
Posted by a reviewer on Amazon
In my case i needed to remove almost all of the major assembliescomponents top panel console top bracemount bracket with main board front panel with door attached lint trap assembly blower cover front support bulkhead for drum and drum
Posted by a reviewer on Amazon
Obviously multiple harnesses needed to be disconnected to remove the above parts
Posted by a reviewer on Amazon
Just unclip the harnesses and gently wiggle apart
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found