What does this mean?Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
It is a tremendous upgrade over the bead, the dot is so easy to pick up in any lighting conditions.
Super easy to install, just pushes right on with some force.
This sight is a great upgrade for the single bead and works great for most lighting conditions except very low light and darkne... Read More
Lastly use a flat blade screwdriver to push the sight forward so the front notch is centered around and against the front bead,... Read More
Price
410 barrel than a 12g, so pay close attention putting it on.
Competitiveness
I had previously installed one of these on my mossberg 500 12g and was pleased with the results.
410 is so much less than the 12g, it's trickier to get the walls to spread.
Overview
- How are reviewers describing this item?
plastic, right, front, easy and optic. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 1,463 reviews as of our last analysis date on Apr 3 2025.
Helpful InsightsBETA
Posted by a reviewer on Amazon
It is a simple design with a bead sight
Posted by a reviewer on Amazon
This sight is a great upgrade for the single bead and works great for most lighting conditions except very low light and darkness where its the same as a bead sight
Posted by a reviewer on Amazon
I would love to see truglo put this out with a tfo tube
Posted by a reviewer on Amazon
Then holding the breech end of the sight barrel against the weapon barrel push down and back on the front of the sight at a 45 degree angle until the back end of the sight barrel snaps over the weapon barrel keep up pressure as you continue to press the front of the sight barrel back and down to get the rest of it around the weapons barrel
Posted by a reviewer on Amazon
Just make sure you dont press on the fiber optic tube itself
Posted by a reviewer on Amazon
It will snap right into place
Posted by a reviewer on Amazon
Lastly use a flat blade screwdriver to push the sight forward so the front notch is centered around and against the front bead being careful not to scratch the weapons barrel
Posted by a reviewer on Amazon
You might have to rotate the sight barrel a little to straighten it out so the fiber optic tube lines up straight with the sight line of the weapon
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Add Fakespot to your browser, Secure Shopping on the go.
