Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Fit perfect in a 3/4 dado grove. Only negative point is that the screws are 5/8 in length which is just a bit too long if you are mounting the tracks onto a 3-4 mdf or plywood base. Very accurate, high quality and durable.
Used it to hold down a clamp. Working great. Going perpendicular is an absolute necessity. Used on a homemade table saw, worked great.
Better price point than a number of other brands available on amazon. Much less expensive than other brands.
Cons
The countersunk screw holes have been hand drilled and are not even, symmetrical, or smooth. The material is good, but the width of the channel doesn't fit most regular bolts. Very frustrating to loosen & re-tighten.
Highlights
Quality
I didnt have any problem with the screws as a few others mentioned
After dealing with imported wood screws made with butter soft steel i was very pleased with the hardness and slot fit of the ph... Read More
Price
Would use them again as price was right
Great value for the price i paid for them
Competitiveness
Fit in with those purchased direct from kreg
Once i finish this project and lumber prices decline i will be tackling a table saw outfeed table workbench which will require... Read More
Overview
- How are reviewers describing this item?
great, good, quality, fit and down. - Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 91.
- Previous analysis of this listing was an D grade.
- Our engine has profiled the reviewer patterns and has determined that there is high deception involved.
- Our engine has analyzed and discovered that 57.3% of the reviews are reliable.
- This product had a total of 1,659 reviews as of our last analysis date on Apr 16 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Screws were a bit too long for the 34 plywood i installed the t track in
Posted by a reviewer on Amazon
The screws that are included are way too short to hold the tracks down when i am cranking down on the clamps that are in the tracks
Posted by a reviewer on Amazon
The 12” screws are too short for heavier loads
Posted by a reviewer on Amazon
Be very careful when using the router to cut the slots in your bench
Posted by a reviewer on Amazon
Well the cut slot measured exactly what was needed according to the diagram but was not wide enough for their t slots
Posted by a reviewer on Amazon
I couldnt even pound them in with a rubber mallet
Posted by a reviewer on Amazon
I predrilled all the holes and didnt get carried away with tightening them with a drilldriver
Posted by a reviewer on Amazon
The media could not be loaded
Review Count History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found