Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Used a 1 & 1/4 inch structural steel pipe to mount a starlink antenna (dishy). This mount is used on the gable-end of my garage for starlink's dishy receiver of low-earth-orbit internet service. If your installing an expensive antenna, i think fla... Read More
Cons
Sturdy, but missing all hardware including the 2 metal plates needed to secure mast in place. Also the finish is not the cadmium plating shown, but appears to just be steel?
Highlights
Competitiveness
The carriage bolts and lag screws were in a small ziplock bag
The mount structure and hardware was shipped in a long thin box which was packaged in a longer amz box
Overview
- How are reviewers describing this item?
bottom, sturdy, nuts, made and heavy. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 137 reviews as of our last analysis date on Mar 16 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I would be hesitant to trust standard nuts since it would be a disaster if they worked themselves loose
Posted by a reviewer on Amazon
It didnt come with flat or lock washers just the lag bolts regular bolts and nuts not lock nuts
Posted by a reviewer on Amazon
Also perhaps a 6 pole was too much
Posted by a reviewer on Amazon
It is sturdy and isnt going anywhere but if i push on it about half way up it wobbles more than i would like due to some flex of the bottom bracket
Posted by a reviewer on Amazon
This is because the bottom bracket is 2 pieces bolted together
Posted by a reviewer on Amazon
I have it at the widest setting which leaves the least overlap of the bottom 2 pieces
Posted by a reviewer on Amazon
I may attach another piece of metal a foot or so long across the bottom bracket to reduce the flex
Posted by a reviewer on Amazon
Lastly if you use this for starlink and use a 2 diameter post and starlink post mount like i did or you want to run your cable dfor whatever youre mounting down the inside of your pole go ahead and use your angle grinder to cut a notch in the bottom of the post for the cable
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found