Posted by a reviewer on Amazon

Beware the ribbon cable at the connectors wrapped over the top with the clamp which means that it will not fit into a raspberry pi case

Posted by a reviewer on Amazon

All the pins are clearly labelled so theres no excuse for for blowing your circuits

Posted by a reviewer on Amazon

Not bad be careful though as its not very obvious the this is for the older pi models doesnt fit the b

Posted by a reviewer on Amazon

This only works for the model a

Posted by a reviewer on Amazon

Ive cut my rating from 4 to 5 stars as once you contact sintron to request the pdf project documents documents they supply about 60mb of docs but none of them offer specific projects for using the components from the kit servo motor etc

Posted by a reviewer on Amazon

My only downside comments on this would be that the breadboard is quite small and the cobbler that did fit into the breadboard ok is just a column of pins wider than you would like and means that you lose a column of pins you might want to use

Posted by a reviewer on Amazon

They promptly sent me a link to this when i emailed them as it didnt come in the box

Posted by a reviewer on Amazon

Does the job gives access to the additional gpio pins on the pi b