Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Overview
- How are reviewers describing this item?
material, great, hot, flexible and right. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has determined that the review content quality is high and informative.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 38 reviews as of our last analysis date on May 22 2020.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Print under 20mmsec at 230c hot end
Posted by a reviewer on Amazon
Its just as advertisedreviewed in um reviews
Posted by a reviewer on Amazon
I know ninjaflex is a good brand so ill give them a good rating but if you plan on even putting semiflex in your bowden extruder you will have a bad time
Posted by a reviewer on Amazon
Had previously tried filaflex with a shore hardness of 82a which did not print with the ultimaker
Posted by a reviewer on Amazon
I printed a couple of beautiful prints on kapton and the print bonded to the kapton and i could not get the two to separate
Posted by a reviewer on Amazon
With blue tape be careful to use tape without writing because if the print is too hot the writing from the tape will sometimes stick to the print
Posted by a reviewer on Amazon
Right off the bat the temperature that you must print with this stuff is a very narrow range band
Posted by a reviewer on Amazon
Too hot or too cold and it just doesnt flow right
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found