What does this mean?Pros & Cons
Pros
This product has its place but as said before, if you have the solder option, use it first. The glue takes a long time to properly mix. Repaired my biometric safe using 5 vdc.
Cons
If resistance is under 100 ohms, it is adequate. After applying it as described, connecting a 10k ohm resistor, the lowest i've gotten so far is 64k ohms. Nowhere near a real conductivity. Not a drop of electrical connectivity.
There was no adhesive from this product. The glue has nothing to do with it. Not worth the frustration it created.
When the container lid was removed there was a ball of hard martial stuck to the side of the container in a pool of liquid. That is frightfully vague. Let dry for 24 hrs.
Highlights
Quality
Perfect to attach smd 10k resistor to wheel axels for bld168 detection
This glue is easy to use after all that stirring and holds well
Leaks of glue onto the clamp surface caused the joint to fail when the clamp was removed after overnight drying
Coated end of wire completely stuck in the switch held it there with masking tape until cured
Price
Seemed a bit pricey for the amount but then again worked great for specialty repair
I used it to reattached the positive battery terminal connector for a standard 9v battery for only a couple of compared to the... Read More
Competitiveness
Id still prefer solder when possible but might consider this still got more than enough for lots of connections
Overview
- How are reviewers describing this item?
conductive, dry, small, great and dried. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 1,493 reviews as of our last analysis date on Apr 27 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Used it to glue batteries together less is more very brittle when cured use epoxy after it dries to keep any moving
Posted by a reviewer on Amazon
I had a playstation 4 controller were the wire for the vibration coil came off of the circuit board
Posted by a reviewer on Amazon
So i bought some hoping it would be the fastest and easiest way to fix it
Posted by a reviewer on Amazon
I had to stir it for about 15 minutes because it was water on top and thick on the bottom
Posted by a reviewer on Amazon
Make sure you stir the wire glue thoroughly otherwise you will get inconsistent results
Posted by a reviewer on Amazon
Know that the conducting wires need to touch each other
Posted by a reviewer on Amazon
The light and input wires were very thin and were soldered to a small electronic board
Posted by a reviewer on Amazon
When i removed them and stripped them for contact i just knew they were going to pull apart and i also remembered i bought this to do something similar to a cooling fan inside a computer
Review Count History
Price History
