Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
One of the first things you'll want to print is a filament guide and spool holder. If you're new to 3d printing, this is the printer for you.
The printer comes fully disassembled in acrylic laser/waterjetted parts. Good steppers, an ar arduino mega and a ramps board, and they even give you a spare stepper driver board if you need another one.
Review of the reprap guru pursa i3 v1 printer. Tl;dr, here's a shopping list if you get this printer. Abs is fun, and now want to try pla.
The instructions include high-res pictures and detailed explanations. Almost everything needed is in the manual in the google drive. It's nice that they have both code and connectors for max pins and min pins, but the directions should be consistent w... Read More
The z axis uses threaded rods on nuts, and the x and y axis use belt drives on linear bearings. The stop sensor for the x axis is mounted to one of the slide rods, but this rod has a huge amount of side to side play, so i can see how it could move dur... Read More
Cons
The website for this product no longer exists. This product *, and i'm apparently the last * they got. Not beginner friendly. Not expert friendly.
Highlights
Quality
The quality of the fabricated parts are excellent
But after that i am very happy with the printer
My only complaint about the printer kit quality is the endstops theyre pretty weak
I sat this quality wise next to a 1500 dollar printer and this thing blows it away
Price
I purchased this reprap guru printer kit when it was at a very low price in early november
Shipping
Just got mine in the mail really loved the fast shipping and easy assembly
Packaging/appearance
Packaging 910 everything is packed really well from the individually bagged and labeled hardware to the custom cardboard holde... Read More
Competitiveness
Will definetly buy from again and will always recommend
Id recommend using it with a raspberry pi and install octoprint
Overview
- How are reviewers describing this item?
good, great, first, quality and few. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 111.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 142 reviews as of our last analysis date on Aug 3 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Works well with pla the hotbed takes awhile to heat up and for me does not get hot enough to print pla without the wireless printing software i am using timing out and stopping
Posted by a reviewer on Amazon
The acrylic supporting the hotbed warps some causing it to be hard to keep level
Posted by a reviewer on Amazon
Once it is leveled it prints well
Posted by a reviewer on Amazon
I wanted to buy a 3d printer ever since i tried it for the first time in highschool
Posted by a reviewer on Amazon
Great product finished assembly and config earlier today and just finished first prints
Posted by a reviewer on Amazon
First off as others have noted if you want to merely unbox it and hop into printing this is not for you
Posted by a reviewer on Amazon
I honestly did not expect that the print quality could be this good from a machine that is half the cost of most others
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found