Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
The quality of this filament is comparable to the more expensive brands that i have used the roll was in an airtight plastic w... Read More
The quality is high and represents a good value in its price range
Prints came out very nice and with the glitter giving it a nice shine layer lines were not even visible in my print
Just tried this for the first time the print quality was great and i had no layering issues
Shipping
1st of all the shipping was super fast
Packaging/appearance
Packagingcomes nice tight seal in the bag with moisture packaging thingy
It came packaged with silica and wasn’t brittle out of the package
Competitiveness
It is easy to print but likes a little warmer temperature than other geeetech pla filament
I highly recommend the geeetech brand and will continue to use it for my future printings
With the geeetech brand you never have to worry about a bad spool
8 profile with minor tweaks to support spiralizer mode along with a few of my other standard test prints at
Overview
- How are reviewers describing this item?
great, color, nice, good and quality. - Our engine has profiled the reviewer patterns and has determined that there is high deception involved.
- Our engine has analyzed and discovered that 24.4% of the reviews are reliable.
- This product had a total of 2,499 reviews as of our last analysis date on Jun 23 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I still need to fine tune my printer and figure out why the trunk didnt turn out
Posted by a reviewer on Amazon
No temp instructions in the package or on spool
Posted by a reviewer on Amazon
Wouldnt stick well until 61° and then when the 16 hour project was over it was hell to peel
Posted by a reviewer on Amazon
Being a shiny silver what a better print test it with than a colossus from the xmen which the file came from myminifactory
Posted by a reviewer on Amazon
While there is no recommended temperature settings on the spool it seems to run close to what other silky temps of pla run on my machine
Posted by a reviewer on Amazon
It ran fine in my a10m printer
Posted by a reviewer on Amazon
I tried it out on these tool holders
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found