Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
V dc adapter model anu (as printed on the adapter) works perfectly for my dymo 210d label maker. It plugs into the label manager straight so there is no angle to fray. My unit is clearly imprinted with + polarity on the outer ring for the same model n... Read More
This adapter is a money saver. Put new batteries in and repeat. Replacing an original part. Allows one to use label maker without batteries.
Cons
Only lasted about 5 months, under very light use. Listing and manufacturer picture shows negative polarity.
Highlights
Quality
Cheapest plug for my could find for the product that i needed it for nothing special
The fit and finish of power supply as well quality of the connector was a surprise given the low price
I had to order another adapter with the correct polarity
Again this adapter went with the total gift
Price
After looking for several weeks i finally found this one and was surprised to see that it was about half the price
Competitiveness
This power cord works great with my ptouch
I had bought an item similar to this but at twice the price
Overview
- How are reviewers describing this item?
fine, great, plastic, short and correct. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 8.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 433 reviews as of our last analysis date on Jul 30 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Male metal connector barrel is a little short but i did not have to trim the plastic back to obtain a firm connection
Posted by a reviewer on Amazon
Couldnt help but check this power supply with a multimeter 9 volts dc most importantly the tip the center conductor was the negative and the ring outside barrel was positive
Posted by a reviewer on Amazon
If you want to use it with the dymo labelmanager 160 youll need to shave a little bit of the plastic off so that it stays firmly plugged in
Posted by a reviewer on Amazon
I dont use my label maker regularly but 3 times ive put fresh batteries used it once store it pulled it back out 4 months later to use again
Posted by a reviewer on Amazon
And the lm160 isnt exactly a battery friendly machine
Posted by a reviewer on Amazon
Know the polarity that you need before you order
Posted by a reviewer on Amazon
I just saw 9v adapter and ordered
Posted by a reviewer on Amazon
Imagine my disappointment when it arrived and wouldnt work
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found