Highlights
Quality
Package arrived promptly and product works as expected
Very happy with the finish and ease of use
Shipping
Very good plasterit arrived very fast also
Packaging/appearance
The models were ready to come out of the mould within 20min and were left out to dry for a few days they will need this dependi... Read More
Competitiveness
The instructions tell you what volume of water is needed i didn’t use it all at once and instead took out 200g at a time and mi... Read More
If you are using this in conjunction with woodland scenics rock molds you will get a 80 success on castings
Overview
- How are reviewers describing this item?
good, great, found, easy and ok. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 303 reviews as of our last analysis date on Dec 29 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I found the plaster solution itself easy enough to make though you do need to add a fair old bit of it to water when making the plaster solution just keep adding the powder to the water carefully with a large spoon like you were adding sifted flower without stirring until you start to see little mountains forming on the top of the water which do not sink
Posted by a reviewer on Amazon
Getting rid of all the air bubbles in the casts was a bit tricky
Posted by a reviewer on Amazon
I eventually found a combination of 1 not stirring until all the powder had been carefully added to the water and leaving it to soak for about a minute 2 stirring in a way that minimised adding air to the mix a flat wooden stick stirring in one direction not removing it from the plaster while mixing 3 allowing the mixture to stand for a minute or so after mixing tapping sides of container firmly to help bring any trapped air to the top 4 half filling a mould with plaster and by pouring as close to the top of the mould as possible and letting it slide in down one side like pouring a beer into a glass to minimise air bubbles then squeazing it to remove any air pockets before carefully filling to the top and 6 once full tapping the sides of the mould or its flange together pretty much irradicated bubbles altogether
Posted by a reviewer on Amazon
Even using the trick of putting talc or washing up liquid though be careful with this as it slowly degrades the latex mould over time on the outside of the mould to stop it sticking to itself as you peel it back i found the plaster very brittle and quite often lost little parts of the cast as they just broke away as i attempted to demould them
Posted by a reviewer on Amazon
It didnt pull of her fur added it to the mould beforehand
Posted by a reviewer on Amazon
This is due to bad casts and inconsistencies in mixing ratios
Posted by a reviewer on Amazon
Add water stir pour watch it set
Posted by a reviewer on Amazon
Its is not a piece of cake to use but not rocket science either if you follow the instructions closely