Posted by a reviewer on Amazon

It should be noted that in addition to being used as advertised e

Posted by a reviewer on Amazon

While the clamp does slide into the festool track it can only be used on the ends of the track but cannot be advanced further unless material is ground off at the elbow of the clamp

Posted by a reviewer on Amazon

It does work fully with the mft and can advance in the side profiles

Posted by a reviewer on Amazon

The dimple must be ground off if you want to separate the screw arm from the bar

Posted by a reviewer on Amazon

Mft dog holes you know that the thickness of the worktop must be no greater than 34 or the elbow cant make it through the dog hole unless you separate the two parts of the clamp and bring the bar from underneath

Posted by a reviewer on Amazon

However over time the bolts caused the table to bow

Posted by a reviewer on Amazon

Wish these would also fit festool but the shaft at the bend is just a little too wide

Posted by a reviewer on Amazon

These will fit partially into the festool track saw guides but they wont slide all the way into the festool dovetail channel