Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
I shoot a lot of range brass, often from a multitude of manufacturers, and fired out of who knows what. This die undersized the brass so it will feed perfectly in any of my 9's. Corrects any bullet bulge and returns the loaded cartridge to factory spe... Read More
Cons
Threads were stripped on the die and decapper retainer. The directions say “considerable toque force may be necessary’.
Highlights
Quality
This die has a special place in loading 9mm for its ability to size the case tighter in some brass that have thin walls and nee... Read More
«great product for sure pretty much a must use for range brass and uspsa type speed shooting where everything must chamber
After setting up the undersize die all my brass easily slips in and out of the case gauge
This undersize die sized the brass well and made brass fit the go gauge
Price
Great reloading die at a great price
Shipping
Came quicker than expected makes reloads chamber more reliably
Competitiveness
Like it better than the dillon and egw die it replaced 🤷
The lee factory crimp die is great also but certain brands of cases need tighter hold on bullets
Overview
- How are reviewers describing this item?
great, lee, sized, undersized and size. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 142 reviews as of our last analysis date on Feb 12 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Measured against 2 types of new cases
Posted by a reviewer on Amazon
Not undersize but back to factory specifications
Posted by a reviewer on Amazon
I replaced my decappingresizing die with this one plus a lee fcd due to issues with 34glock bulge34
Posted by a reviewer on Amazon
If you are going to use it with a dillon rl1100 you will need to put the nut on the bottom not on the top of the tool head since the die is too short
Posted by a reviewer on Amazon
With that said if you add any lighting system like i did on the bottom of the tool head you will not be able to put the nut on the bottom and there is really not enough threads keep it locked
Posted by a reviewer on Amazon
You need to really tighten it to keep it from slipping on a tough primmer to be decaped
Posted by a reviewer on Amazon
As mentioned its nice just too short for the rl1100 tool head
Posted by a reviewer on Amazon
One of the complaints about the partial length dies is that they leave a ring where the sizing stops
Review Count History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found