Posted by a reviewer on Amazon

A couple things to point out though if you have sensors that are tied together it will not recognize the difference

Posted by a reviewer on Amazon

To give an example i had two doors that were spliced together and when i would open either one the panel would report them as the same door

Posted by a reviewer on Amazon

My solution was to run a new line and put each door on its own zone

Posted by a reviewer on Amazon

I then reran to the other zones that were spliced together and seperated them to work the way i wanted them to

Posted by a reviewer on Amazon

I tried without and no luck also there is a tamper magnet in the cover it will throw a tamper code if it’s not installed mine the magnet itself was in the assessors kit and not attached to the cover it took me a few mins to realize the magnet wasn’t installed at the factory

Posted by a reviewer on Amazon

Without a battery it will send a message to the screen that there’s no battery connected

Posted by a reviewer on Amazon

Somewhat spotty it looses the signal every once in a while

Posted by a reviewer on Amazon

I have not been able to get the windows working on it yet