What does this mean?Overview
- How are reviewers describing this item?
first, good and few. - Our engine has profiled the reviewer patterns and has determined that there is high deception involved.
- Our engine has analyzed and discovered that 38.7% of the reviews are reliable.
- This product had a total of 117 reviews as of our last analysis date on Mar 26 2019.
Helpful InsightsBETA
Posted by a reviewer on Amazon
A few times the instructions clearly state pay attention
Posted by a reviewer on Amazon
Installing software was rather painless when following directions
Posted by a reviewer on Amazon
The acrylic frame makes it not so solid which can affect the print quality i had to reinforce it with glue to avoid movements
Posted by a reviewer on Amazon
The cura software and instructions are good
Posted by a reviewer on Amazon
For my first print the filament did not stick to the heated bed
Posted by a reviewer on Amazon
I then realized the purpose of the included roll of paper tape and with this in place the print was fine
Posted by a reviewer on Amazon
Mine was bad but i think the set screw was pressing against it too tight and caused a max temp errordont tighten the thermostat set screw too tight or else youll get a max temp error again lolwire everything into the motherboard before bolting the mother board to the printer
Posted by a reviewer on Amazon
This was my first 3d printerbuild and it wasnt too bad initially though it was rather timeconsuming even for someone with a lot of experience building other devices
Review Count History
Price History
