Posted by a reviewer on Amazon

The only problem i had was that the screws were more like bolts so it was hard to put them in the kayak

Posted by a reviewer on Amazon

Also i think enclosing a simple diagram illustrating a recommended position would prevent opposite intended orientation by an inexperienced installer in most cases when mounted behind paddler the hinge of the holder should be rotated somewhat toward tank well to result in rod tilted toward rear of kayak

Posted by a reviewer on Amazon

The bad news the mounting hardware that comes with them will not work on plastic kayaks

Posted by a reviewer on Amazon

Not sure that will hold long term so i may buy longer screws to put a washer and a nut on the inside of the kayak

Posted by a reviewer on Amazon

Then had to angle the hole saw to taper the hole to allow the rod holder to sit flush not a big deal and only takes a few seconds

Posted by a reviewer on Amazon

You could probably drill a slightly larger whole instead to achieve the same result

Posted by a reviewer on Amazon

As everyone else has stated the screws that it comes with are a joke

Posted by a reviewer on Amazon

Not bad quality but the holes are not in a standard location