Posted by a reviewer on Amazon

I experienced no issues printing it and it dissolved enough in a couple of hours to remove it

Posted by a reviewer on Amazon

Dont cook this stuff at over 200

Posted by a reviewer on Amazon

Finish a print pop it off plate and drop it in warm water

Posted by a reviewer on Amazon

Havent figured out if its my settings or the filament but it doesnt seem to stick to pla as expected

Posted by a reviewer on Amazon

I have tried plenty of support configurations and while it sticks to the glass bed just fine it occasionally has issues when sticking to pla and pla doesnt always want to stick to it

Posted by a reviewer on Amazon

Also i noticed that it kinda drips a little after tool changes and despite my tweaks i still cant find a retraction configuration that both stops this issue and allows the nozzle to start printing immediately without priming on a purge wall

Posted by a reviewer on Amazon

It just seems to be slightly more temperamental then pla and will require a lot of trial and error

Posted by a reviewer on Amazon

I will update if i am able to find settings that allow me to print supports reliably