Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
I rated this 5 stars because the quality is great
This filament is very high quality it prints nicely with the right settings
I change the noctua fan since it heat creap bad for motor
I am maxed out on my stock printer temps and am still not 100 happy with the layer adhesion
Price
200 in h20 airflow at least 19 cfm fan to extend your printer life and hotend futher reducing trouble for direct drive motor
Packaging/appearance
That said theey seem to have addressed the packaging complaints mine came very well vacuum sealed
I upgraded to a full metal hotend made an enclosure and took off the fan next to the hotend it causes a lot of warping
Competitiveness
Printing with a wanhao i3 monoprice maker select v2 with all the usual upgrades
Printed at 285c130c on a creality machine the key to minimizingreducing warping is to have an enclosure with a high bed temp g... Read More
Once you get the temps tuned in 270 on a e3d volcano w
You will need a hotend that is all metal so that it can go to 300c
Overview
- How are reviewers describing this item?
good, high, first, still and blue. - Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 15.
- Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 60.9% of the reviews are reliable.
- This product had a total of 103 reviews as of our last analysis date on Jan 26 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I change it to glass bed after many warped print on prusa mk3
Posted by a reviewer on Amazon
If cover 4 side it get too hot 61 c and not recommended
Posted by a reviewer on Amazon
Let it heat first and then put glue stick
Posted by a reviewer on Amazon
On pei sheet it work for smaller print however it a pain in the for trying to apply kapton tape and abs glue every time i take it off it ripped of the kapton sheet and i have to apply it again
Posted by a reviewer on Amazon
Since my kapton tape is 200mm width i have no way
Posted by a reviewer on Amazon
Further if the tape is not stick press well it with lift with the print or you trying to saving the tape and put just small area it will lift too
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found