Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Cons
The seller needs to fix the listing. If the * doesn't seal against the nozzle, it's not worth using. Filament then builds up and oozes out the loose ends of the heat block.
Highlights
Quality
Comes with the allen wrenches to tighten down the heater
I broke my nozzle off when trying to remove it for cleaning and not only were these units low in coast but also very easy to se... Read More
The throats are about 5mm shorter than what came with the anet a2
Competitiveness
These are the correct hotend for the a8 model
Overview
- How are reviewers describing this item?
fit, small, good, plastic and down. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 241 reviews as of our last analysis date on Jun 16 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
The throats are about 5mm shorter than what came with the anet a2
Posted by a reviewer on Amazon
I broke my nozzle off when trying to remove it for cleaning and not only were these units low in coast but also very easy to setup and have good quality prints
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found