Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
Wonderful product works just like they say run it at at least 250deg
If you need to clean out a jam this is a really good product
Whenever i start to have problems with nozzle output quality filament appearing to stick to the nozzle clogging or occasional b... Read More
Packaging/appearance
I also sprayed the hotend with ptfe lubricating spray after cleaning
While the hotend is cooling the cleaning filament is still flowing through the hotend
Watching the temps as the hotend is heating once i hit 200c i would unload the petg and then load up the cleaning filament
Competitiveness
Worked like a champ read some of the reviews and took a change for a stubborn clog
I used this on my flashforge dreamer
So fantastically that i ordered a roll of esuns petg
Fixed both extruders nozzles second pic is a dual extruder print
Overview
- How are reviewers describing this item?
through, clean, cold, material and great. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 409 reviews as of our last analysis date on Mar 3 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
One of the extruders started to struggle pushing filament through and i would have to force it through to start the print
Posted by a reviewer on Amazon
Dont expect this cleaning filament to be as firm as abs or pla when hand feeding into your nozzle
Posted by a reviewer on Amazon
I had to use pliers as close to the fending apparatus as possible to prevent it from bowing before entry
Posted by a reviewer on Amazon
Be careful if you push too hard it will kink and you will have to pull it out and push it back in again
Posted by a reviewer on Amazon
It cleared a nasty plug of pla out of the hot end
Posted by a reviewer on Amazon
It is a bit of a pain to feed into the printer though and the printer gives me error messages when it is in it because it is irregular
Posted by a reviewer on Amazon
It feels rough to the touch but it goes through the extruder smoothly
Posted by a reviewer on Amazon
After running a foot of this through the nozzle the problem has resolved itself
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found