Posted by a reviewer on Amazon

It did need the typical adjustments such as the center line added a 116 shim between the bearing arbor and the stand the lower mount was not at 90 angle vise and a hammer with an angle finder to correct this issue the included degree markers are not even close i always remove them anyways and use a digital angle finder

Posted by a reviewer on Amazon

There is not enough height to allow through cutting a full 60 cutting angle on any diameter tubing larger than 1

Posted by a reviewer on Amazon

Will need some shim to align it correctly

Posted by a reviewer on Amazon

This notcher is a made in china junky notcher

Posted by a reviewer on Amazon

The clamp did night line up with the drill shaft correctly out of the box

Posted by a reviewer on Amazon

So i was forced to shim between the clamp and housing with thin washers to get it to line up

Posted by a reviewer on Amazon

Without shims it was leaving part of the steel pipe intact on one side

Posted by a reviewer on Amazon

And for a hundred bucks it was like the old saying you get what you pay for