Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Excellent product, delivered on time for a reasonable price. Used all 100 leds and all worked. It's far better than the original configuration. Would buy again. And 6.
Cons
Even with properly installed current limiting resistors, these leds get very dim after a few days of operation. After long periods of use, they go into a constant blinking or just dim - indicating failure.
The price is right, but the frustration of replacing them is very inconvenient. The info says 1500-2000 mcd, but there is no way these are close to that! Do not buy. A complete rip off.
Highlights
Quality
In any case i thought the quality and price were very good and i would recommend them anywhere a flashing display is desired
While the number of possible displays was much greater with the arduino adding the hardware and software seemed like too much w... Read More
Price
If you calculate it right ๐ price was resonable as well for the qualiy received
Packaging/appearance
On one side it was about a 1mm too long so i snipped off the very end of that one with wire cutter
Competitiveness
Run for days on a 3v coin cell too
Heads up though if you are using a solderless breadboard it can get messy
They can run directly off of the cr2032 batteries the button cell batteries that are about the sizeshape of a quarter
Overview
- How are reviewers describing this item?
bright, great, color, good and far. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 71.3% of the reviews are reliable.
- This product had a total of 2,655 reviews as of our last analysis date on Oct 28 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
If they arent lighting the color that you want it might be that the leads and the resistors are touching
Posted by a reviewer on Amazon
Even with 180 ohm the current draw appeared to be less than 10 ma
Posted by a reviewer on Amazon
One could possible go with a lower value resistor any they would be even brighter
Posted by a reviewer on Amazon
The media could not be loaded
Posted by a reviewer on Amazon
While the number of possible displays was much greater with the arduino adding the hardware and software seemed like too much work for a simple project
Posted by a reviewer on Amazon
I think this is the linkย
Posted by a reviewer on Amazon
They worked just fine but it seemed like the flashing rate was too high and maybe the overall brightness of a rapidly flashing display was too much to be on all of the time
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found