Pros & Cons
Pros
The angle connector is nice for changing the direction of the pins. I have been building my own custom gaming pc's for 40 years & this is nice.
The soldering of the connections looks solid and sturdy. Solid solder application, it's sturdier than i expected it to be.
The angle connector fits perfectly in a lian li ii mesh case. Fits snug. Not fancy like some that have a plastic casing, but sometimes those are too bulky.
Cons
I want to be fair about this product and disclose that i had a specific goal that this adapter did not meet. Pulled it off, disconnecting from the cable as well as the motherboard. The fit (quality) of the plastic housing for the connector pins is ver... Read More
Highlights
Quality
The quality is good on this piece
I cant find any fault with the plug
Overview
- How are reviewers describing this item?
clean, plastic and great. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 483 reviews as of our last analysis date on Apr 27 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Nearly impossible to pull off the board once you install it
Posted by a reviewer on Amazon
The last thing you want to be dealing with is more wires when youre building a computer if youre doing wire management
Posted by a reviewer on Amazon
The downside of it too though is it is very hard to remove it from the power header on the motherboard once its installed
Posted by a reviewer on Amazon
Its easier to remove replace it
Posted by a reviewer on Amazon
You can’t see them after it’s installed
Posted by a reviewer on Amazon
Space is tight in the raijintek styx microatx case that i built my pc in
Posted by a reviewer on Amazon
Small form factor pcs can be a challenge for cable management to keep the build looking clean and not messy
Posted by a reviewer on Amazon
This had caused problems with stress from the pressure where the wires plug into the cables plastic connector jeopardizing stable power flow into my board and causing erratic crashes until i adjusted the bend slightly