Pros & Cons
Pros
Used this to chase rusted frame threads for a 2015 rdx trailer hitch. It rethreads bolts/screws/etc. Now my lathe is good to go.
Suprisingly well machined and finished for the money. My job is not leaking so good is good.
O2 sensor slot of the catalytic converter. Appears to actually be hss and not just a chrome blasted high carbon tap.
Cons
The tap is cheap carbon steel. It has no stamping or laser etching. Two turns into the job and the tap is dull as *.
Highlights
Quality
Quality tap good cut and fit was correct size
It did an excellent repair and i am totally satisfied
Just be gentle and patient with the whole process
Packaging/appearance
Was able to rethread my oil pan drain hole that was stripped
Competitiveness
Worked gread for cleabing isuzu 4hk1 head bolt holes
Overview
- How are reviewers describing this item?
good, great, size, clean and new. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 71.4% of the reviews are reliable.
- This product had a total of 2,936 reviews as of our last analysis date on Aug 12 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
I was kind of worried it would nbreak like the first one did
Posted by a reviewer on Amazon
With some antiseize and 10 minutes of work i was done
Posted by a reviewer on Amazon
I did some motor work on my hemi and when it was time to put the super damper back on my crank threads stripped clean off i went up slightly in size from m14x1
Posted by a reviewer on Amazon
The better cheaper and more hopeful option was to rethread
Posted by a reviewer on Amazon
Its possible to do this with a drill but i prefer by hand
Posted by a reviewer on Amazon
Less chances of drilling out the slot instead of threading it
Posted by a reviewer on Amazon
Just remember that a quarter inch of the end of the tap is not thread so youll want to go farther into the slot by about 14 quarter inch to get a full threading completed
Posted by a reviewer on Amazon
Slowly remove the tap bit by unscrewingturning it back out