Posted by a reviewer on Amazon

Good quality pla but it doesnt look as nice printed as it does on the reel

Posted by a reviewer on Amazon

Had to print at 220c to get proper layer adhesion

Posted by a reviewer on Amazon

The picture is a celtic skull 6 by 5 x 7 cm with a battery tea light underneath it

Posted by a reviewer on Amazon

The translucent effect is a little dim and if you print a solid piece is barely noticeable

Posted by a reviewer on Amazon

I ran the entire 10 hour print job straight out of the box with the default pla settings in prusa slicer 2

Posted by a reviewer on Amazon

I printed the same model in cherry red metallic proto pasta htpla and had some print artifacts that required postprocessing but i had none of those issues with this solutech pla

Posted by a reviewer on Amazon

Quality and value here are easily comparable to the inland pla that i use for most of my print jobs including the lightsaber hilt in the photo but the inland neon green is nowhere near as bright a color

Posted by a reviewer on Amazon

Good adhesion nice sheen decently translucent especially in vase mode single wall no infill