Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
Once i had the correct settings this works exactly as described i dont need a raft or brim anymore and the quality of the first... Read More
My only minor complaint would be that perhaps the product works a bit too well
This product works well with the dc42 ir probe as i get a decent first layer everytime
I decided to finally pull the trigger and purchase and cannot say i am disappointed in the slightest
Price
The price was good and more than big enough for the 350 x 350 bed
I love it adhesion for pla petg and abs is fantastic and i dont feel like im just gonna rip a section off like the stock prusa sheet
Shipping
Quality is there shipping was fast and well packaged
Packaging/appearance
Prints with temperatures of 205210°c in the hotend and 60°c on the bed make adhesion really not an issue
Competitiveness
I use this on a metal removeable flex plate which is the best technology today
These normally are about the price of these four just for one so i had my doubts
For those that think it sticks too well get a removeable bendable plate
They describe as a 16x16 sheets but if you look at the photos they post you can see that it is written on the sheet that they a... Read More
Overview
- How are reviewers describing this item?
surface, first, great and down. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has detected that Amazon has altered, modified or removed reviews from this listing. We approximate total reviews altered up to 1.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 357 reviews as of our last analysis date on Apr 24 2022.
Helpful InsightsBETA
Posted by a reviewer on Amazon
As to the surface itself its sturdy smooth and everything but nylon sticks to it like glue
Posted by a reviewer on Amazon
Every time i would make it a few hours in and either the glass would shift or the part would lose adhesion to the build surface and everything would get slightly offset at best other times just a huge mess
Posted by a reviewer on Amazon
It was very difficult to remove the second part
Posted by a reviewer on Amazon
The printer came with a glass bed that would not hold any models even after roughing with sandpaper
Posted by a reviewer on Amazon
I had a few great prints on my cr10s but then found i was having major problems with adhesion
Posted by a reviewer on Amazon
If anything clearing finished prints off of a room temperature build plate has become the actual issue
Posted by a reviewer on Amazon
Pla sticks fine havent tried anything else yet the only reason for 4 stars is that it is not a full 16x16 sheet
Posted by a reviewer on Amazon
They describe as a 16x16 sheets but if you look at the photos they post you can see that it is written on the sheet that they are actually only 15
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found