Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Easy to install. Works well. Only thing you need is drill and 5 minute of your time for each installation. With these being brass, i expect them to be excellent and long-lasting.
They are under no pressure, so if properly installed, i see no reason why they would leak. Must be tight enough prevent leaking but not too tight. They have paid for themselves just in the gas i'm not spilling all over the ground.
Cons
The neoprene washer worked and the o ring did not. Plastic caps melt when they come in contact with gas. This one works ok but sticks out too much on top of the my 5 gal gas can.
Highlights
Quality
Great product easy to use gas flows out of can easy mix it quick to fill gas tank easy to install
Sturdy and will last for the life of the fuel cans
This has nothing to do with the quality of the product
Feed wire through valve and bend 14 inch to hold into place7
Price
I decided the cost savings was worth it particularly because the caps are extremely common and easy to replace if lost
Competitiveness
Other than that the quality is at least as good as the more expensive set and i do recommend these with the one caveat
I previously had ordered a similar product that worked great but the price had gone up significantly when i came to reorder some more
Overview
- How are reviewers describing this item?
easy, great, plastic, rubber and through. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 492 reviews as of our last analysis date on Mar 22 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
After drilling the holes i turned the cans plastic upsidedown used a air hose to blow out any possible chips
Posted by a reviewer on Amazon
The neck on vent is smaller than the yellow vent caps you get in a replacement spout kit
Posted by a reviewer on Amazon
Never install the vent below the highest possible fill level of your can when it is sitting flat
Posted by a reviewer on Amazon
Why if at anytime down the road of time the valve started leaking it would leak all the gas down to the level of installation
Posted by a reviewer on Amazon
This has nothing to do with the quality of the product
Posted by a reviewer on Amazon
You just cant fit and seal a flat stem on a curved surface
Posted by a reviewer on Amazon
When drilling the hole find a flat space above maximum fill level feed the dill slow and let it drill
Posted by a reviewer on Amazon
I had to reach in and remove the large bur left by the drill with a pair of tweezers
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found