Highlights
Quality
Very pleased with the way this glass bed is working!
Cut perfectly for the monoprice select mini v2!
(original review below for completeness)seems that since they restocked these, perhaps the quality has gone down.
I bought this glass plate for my monoprice select mini v2 and i am just impressed with the change on the printing quality.
Price
Price was a little high (my fault for not shopping around) but it got my printer up and running so i just can't complain.
Packaging/appearance
I like this particular piece of glass because it is sized perfectly to fit the bed of the monoprice select mini v2.
Purchased this threw a direct link in the monoprice mini select facebook group.
Since this is out of the print space it's so far purely cosmetic.
Competitiveness
Using this with a monoprice select mini v2 and it's working wonderfully.
Absolutely perfect for my monoprice select mini v2.
Very clean edges and qualtiy glass as far as i can tell.
Overview
- How are reviewers describing this item?
select, cut, great, little and quality. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 143 reviews as of our last analysis date on Jan 25 2021.
DetailsBETA
BETA
My glass had a small chip on one side. Since this is out of the print space it's so far purely cosmetic. I'll update if the chi... Read More
Helpful InsightsBETA
BETA
Posted by a reviewer on Amazon
They stick well when the bed is warm but are easily popped off when it cools.
Posted by a reviewer on Amazon
I am using high-temperature clear double-sided tape to mount it, with two pieces on the front, and one in the back so the rear adjusters don't flex the glass.
Posted by a reviewer on Amazon
I adjusted the front two screws to get the proper clearance along the front, but i cannot get both rear corners to the correct spacing.
Posted by a reviewer on Amazon
I can compromise along the front, but then all four corners are either too close or too far from the extruder.
Posted by a reviewer on Amazon
This is affecting my prints which is what i was trying to fix.
Posted by a reviewer on Amazon
The picture shows how i mounted the glass.
Posted by a reviewer on Amazon
What i found was that my problem was not with the glass, but was a mechanical issue with the print bed.
Posted by a reviewer on Amazon
The slide bars that the bed traveled on were not parallel, causing the bed to have a twisting motion as it moved back and forth.