What does this mean?
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
This is good - i have not any real complaint. These are far more forgiving than the previous cheapy'metal drills' great for jewelry making.
Cons
These are much shorter than expected but there is no description anywhere to let the buyer know the length. They work fine on wood but if your looking for going through hardened steel, i can not recommend them. They look like factory rejects.
Highlights
Quality
Great price for the quality and quantities
After getting these in i drilled out 3 times as many with the 1 bit and it was still going when i finally got them drilled out
I was frustrated with the quality of drill bits i found locally could not get through a single job with a single drill bit so i... Read More
Competitiveness
These drill bits are far more forgiving than the previous cheapy metal drills and after some 50 holes very little degradation noticed
Overview
- How are reviewers describing this item?
through, great, metal, stainless and sharp. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 380 reviews as of our last analysis date on Dec 24 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Just a weekend warrior working on landscape project
Posted by a reviewer on Amazon
I was surprised that one of these bits did half the work
Posted by a reviewer on Amazon
The other half burned up the other listed “name brand” bits and i used one of these to finish
Posted by a reviewer on Amazon
Angle iron from bad frame is hard highcarbon steel that burned or blunted many so called metal bits i tried
Posted by a reviewer on Amazon
I am a novice at drilling hard metal and learned to drill slowly and use lubricant and no more than a few pounds of force on the drill press
Posted by a reviewer on Amazon
Though it was advised against i even manged to drill holes with a hand held drill though the hardness of these bits i assume mean they may be brittle and break with offaxis forces if i do much of that
Posted by a reviewer on Amazon
I use a cheap overhead drill press which will stall if the bit catches as it goes though
Posted by a reviewer on Amazon
One of the ten bits did the job quite nicely and was cutting when the job was done
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Initializing Fakespot Chat
System error,
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
