Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
W wedge style clamp has more contact area and provides substantial rigidity. Little to no chatter with 1/2 tools. What still is a puzzle is the provision of two cutting tool holder slots.
Purchased it for my grizzly g0768 lathe. Removed the original tool holder and replaced the mounting stud. After a small mod to my cross slide, this for my lathe perfectly.
Cons
Seemed to me to defeat the purpose of being solid.
Highlights
Quality
Quality as expected but good enough for a hobbyist
Best finishes ive ever seen on this lathe with the same sharp tools
Dont even waste your time with the aluminum blocks this one may be 4x the price but you get what you pay for
I think it will do the job fine for me although not the quality of the much higher priced toolpost
Price
Still an extremely good set for a good price here though
I this it was a very good value considering the price
I was skeptical about buying this thing the price is kind of high for me since i’m just a novice and wasn’t sure about pulling the trigger
Shipping
Seller was fast in shipping and quick to respond to my public question here on this add
Competitiveness
Much more ridgid less chatter less tool tip chipping etc
Overview
- How are reviewers describing this item?
good, fit, set, great and quality. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 80% high quality reviews are present.
- This product had a total of 249 reviews as of our last analysis date on Aug 5 2023.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Ground surfaces and made of steel
Posted by a reviewer on Amazon
Id like to adjust the arm position as in the release position its over one of the tool holders and barely lets you get the holder off
Posted by a reviewer on Amazon
If you own a lathe u should be able to make this fit
Posted by a reviewer on Amazon
If not you should sell your lathe cheap to someone who can
Posted by a reviewer on Amazon
I read a lot of reviews on this tool holder before i bought it
Posted by a reviewer on Amazon
Everybody talking about it being loose and sloppy
Posted by a reviewer on Amazon
That was not the case with mine
Posted by a reviewer on Amazon
Like someone else mentioned i also bought one of those aluminum kits and its not worth it
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found