The sound quality on this thing is actually amazing. No feedback, no noise. The sound signature is quite similar being warm and laid-back. It takes some working with the mic to find that right combination of settings and use.
This is another fantastic offering from vegue which continues to shake up the value market. I honestly think it sounds just as good as one you may pay $150+.
A short press mutes the microphone. The foam windscreen has a snug fit and does not want to fall off. The mute button is super practical and having the option to use usb if necessary is nice.
On the bottom of the microphone is a usb port, an xlr port, and a headphone port. It has a built-in usb-c preamp for simpler setups with onboard gain/monitor controls that works and sounds just fine. Over usb, there is a noticeable noise floor and the... Read More
Comes with everything you need to get set up except a mic stand. Has tripod stand, isolation mount and wind screen included. Comes with a usb cable, a usb type c adapter, and an xlr cable.
The mic feels solid but does not have the 24 bit 48 khz as listed. It also doesn't rotate 360, the box says 94 db snr but the amazon description says 95.
The only downside to these mics is that the wires can get soldered on backwards at the factory so if you buy two, they could be out of phase. The pyle mic was better suited for those frequencies and provided a very nice sound for my project. Great mic... Read More
Are these as good as shure 57s? Bought 2 as a cheaper sm57 alternative. Sounds brighter than an sm57 but very similar still. It sounds good enough that i'd happily sub one for a "real" 57 and not worry it will get dropped or spilled on.
Sure the finish is cheap, but the casing itself feels solid. Bought 2 more right after. Seem to be pretty sturdy too.
Crystal clear highs, beautiful clarity, no boomy-ness. It does a shockingly great job for the price.
This mic is very fragile due to being of poor quality. The sound quality is fair but i don't think it compairs to the shure. When i used them with my mixer, there was too much hissing and cracking.
Soldering and wires are terrible, plus i had the bad luck of receiving one that had solder from one of the wires in contact with the nut the holds the capsule together. The connector on the bottom going to the xlr cable is loose and shakes around.
Unreliable Reviews. Do more research before proceeding
Mostly unreliable reviews. Do more research before proceeding