Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Overview
- How are reviewers describing this item?
good, bent, fine, great and quality. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 70 reviews as of our last analysis date on Jan 20 2020.
Helpful InsightsBETA
Posted by a reviewer on Amazon
It would have been nicer though if they included the firmware object code or even preloaded
Posted by a reviewer on Amazon
This can be corrected in marlin by updating the pins
Posted by a reviewer on Amazon
This one wasnt too hard either if you pay attention to compile errors
Posted by a reviewer on Amazon
Thats not enough to drive the lcd i could get a backlight occasionally but the contrast was awful and one could barely make out the display even if one held it at just the right angle
Posted by a reviewer on Amazon
I contacted kuman and though they directed me to a generic install your full graphics controller video that didnt really help they did respond promptly and i do believe they would have worked with me further if i continued to have problems
Posted by a reviewer on Amazon
Ok first off arduion is the only way to go in my opinion when doing a 3d printer
Posted by a reviewer on Amazon
Melzi boards are horrible and when they fail there is virtually no support
Posted by a reviewer on Amazon
So with that said if you are going to build upgrade or otherwise use a 3d printer buy an arduino
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found