Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Overview
- How are reviewers describing this item?
flexible, good, great, strong and material. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has determined that the review content quality is high and informative.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 138 reviews as of our last analysis date on Jan 26 2020.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Will clog makerbot mini extruder and extruder plus
Posted by a reviewer on Amazon
It has been a little stringy but i am still trying to figure out what setting would be best
Posted by a reviewer on Amazon
If my second extruder hits it while printing it just bends and pops back into place
Posted by a reviewer on Amazon
The filament sticks to itself on the spool
Posted by a reviewer on Amazon
If its stuck too much it can slip in extruder drive because it stretches out
Posted by a reviewer on Amazon
If i pulled it by hand to unstick it then it was fine
Posted by a reviewer on Amazon
As far as print settings are concerned i tend to print ninjaflex slow 20mms or less slow with an extrusion multiplier of about 125 in order to get a solid first layer and better print quality
Posted by a reviewer on Amazon
The prints come out a wonderful shade of purple
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found