Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
The brim is probably overkill, but it works great. The wolfbite stuff is water-soluble too, another great bonus.
The grip of a wolfs bite might be something like wolfbite's grip on abs. No more gluestick, hair spray or abs slurrie. Zero warp risk at 80 degrees. However, and this is the risk i've had with borosilicates, there is a chance of damage if the part coo... Read More
Wont ever print without it. Goes on thin and lasts at least a few prints between applications.
We feel all this modification was worth the effort. I was hooked. Just one thing for a heads up though. Goodbye to all that.
Highlights
Quality
If we get impatient and try to remove a part from a stillhot bed some glass will come up with the partoops
But also i had to deal with the tape
Update 91618 still using this and still very happy
Price
If it continues to work like this i will be very happy and it will be well worth the price
Packaging/appearance
Comes with a little foam brush which juust fits into the bottle
Then you could remove the part without any effort at all
But as others have mentioned it will eat chunks out of the glass surface
A little goes a long way and wait until the bed cools to remove the part
Competitiveness
Ive had the same bottle for over six months and it still is performing like a champ
Helpful InsightsBETA
Posted by a reviewer on Amazon
This stuff smells horrible and on the back of the bottle is a warning about it causing eye and respiratory tract irritation
Posted by a reviewer on Amazon
Recommend that people give it a shot but again beware of the stink
Posted by a reviewer on Amazon
The plate fully cools overnight and my finished part will already be separated from the glass
Posted by a reviewer on Amazon
However it does not adhere to borosilicate glass
Posted by a reviewer on Amazon
Like so many other printing with abs i have tried every single technique out there abs slurry glue water mix hairspray blue tape kapton tape etc
Posted by a reviewer on Amazon
I printed a very large part in abs 180 x 80 mm to test the effectiveness of this product and i had absolutely no warparge no edge curl
Posted by a reviewer on Amazon
It was not explained to me what this was
Posted by a reviewer on Amazon
Now i had a heated bed on my um and it did an ok job but still i had curling on my prints
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found