Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Pros & Cons
Pros
Gives my prints a glossy shine on the bottom. I print directly onto the glass without any additional glue or hairspray. Only issue is that the clips can only be mounted in certain locations so they dont run into the printer itself.
Sizing is just right. This is my second glass bed for my msp and it's perfectly sized for the bed.
Cons
Glass is unlevel / bowed, which made it unusable and impossible to level. Even set it in a level surface and two corners bounced. Concern about cracking during heating/cooling.
Highlights
Quality
Amazing best cutting board i ever bought the vegetables stick just enough to the glass to cut comfortably and they slide off with ease
This made printing 10000000x easier and is great quality
Parts always stick well enough to hold during printing and they “snap” right off the glass when done with very little effort
And at the end of the use just rinse off with water and its as good as new still wash it of course just amazing love glass cutt... Read More
Packaging/appearance
No issues shipping box was well padded
Competitiveness
This fits well on monoprice maker select
I have another printer with blackdiamond glass which works well but not this well
Overview
- How are reviewers describing this item?
select, great, surface, right and down. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 253 reviews as of our last analysis date on Feb 29 2024.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Is it takes a couple minutes longer to heat the bed
Posted by a reviewer on Amazon
I tried taking one off while still warm and glass shattered
Posted by a reviewer on Amazon
I had to turn the bed temp up 10 deg to get good adhesion but other than that this was a smooth install
Posted by a reviewer on Amazon
Before this glass i was having problems getting a print to stick the bed has become warped like a bowl lower in the middle
Posted by a reviewer on Amazon
I wish very much that i had gotten this for my printer when i started
Posted by a reviewer on Amazon
I have had a very high print success rate after i switched to this glass bed and an application of elmers stick glue before every print
Posted by a reviewer on Amazon
After each print i take the clips off and remove the glass
Posted by a reviewer on Amazon
After that just dry the glass and reclip it onto the printer
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found