Highlights
Quality
Now that ive had it in operation for a few weeks i must say i am very impressed with the stability and low noise of this power supply
Good quality got the voltage and current i needed thanks
I dont see any problems with the unit being unsafe
The only problem i had with the supply was purely my own fault
Shipping
But for 22 with free shipping i think this power supply is worth the gamble to save 100
Competitiveness
Update after two yearsthe unit is still going strong with no issues whatsoever over the last 2 years 247 use
Using it to power amateur radio projects
The 230v setting is the safest setting to have the supply set to if you connect it to a 120v 115v source it will do nothing
I have two of these power supplies to run 8 60w rgb led strips works great
Overview
- How are reviewers describing this item?
good, great, radio, quality and two. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 80 reviews as of our last analysis date on Jan 22 2021.
Helpful InsightsBETA
BETA
Posted by a reviewer on Amazon
The fans are the weak point they only last 18 to 24 months in this 24 hour operational environment
Posted by a reviewer on Amazon
I failed to move the switch to the 115v position prior to testing and spent more time than i should have troubleshooting my wiring to try and figure out why nothing worked
Posted by a reviewer on Amazon
The 230v setting is the safest setting to have the supply set to if you connect it to a 120v 115v source it will do nothing
Posted by a reviewer on Amazon
Were it set to the 115v position and it was connected to a 230v source the magic smoke would very likely escape
Posted by a reviewer on Amazon
The end result would be a dead supply at best
Posted by a reviewer on Amazon
Fan is not variable speed on mine
Posted by a reviewer on Amazon
It is much smaller than envisioned
Posted by a reviewer on Amazon
Pot range of motion is less than 180 degrees so it takes micro adjustments to get it to a desired single decimal place and to the hundredth of a volt is extremely difficult