The full-spectrum 25-watt output is incredibly bright. It can be considered equivalent to a 150-w watt conventional bulb of yesteryear. The light panel is large, measuring 8. Inches.

Unit as a whole is lightweight and easy to maneuver. Utility is relatively high. Allows you to put a tray of plans directly over it. Shipped fast & in great condition.

The base is stable enough to balance the fixture unless twisted into an awkward position. At full extension ( as in the photos ) as you tilt the light, it wants to tip over. The extendable pole holds it very well.

The most stellar feature of this light is - the controls. The daisy chain feature is great as you only have to plug one into the outlet. Plant seems to be adapting to this light pretty well.

Sturdy tripod and lighting head appears well made. It's very sturdy and heavy so no worries about it getting easily knocked over. The telescoping stand is also very nice.

The gooseneck and clamp that it's attached too is far too flimsy to hold it. Also, the goose neck is extremely short. It's hard to clamp it to a table without the head of the light being right up on the plant.

It is so bright, but i think my cactus is liking it. At 6,000 lumens this light puts out about the same as 4-100 watt bulbs. It just amazes me how far lighting technology has come, that you can get something with this amount of brightness for so cheap...  Read More

Ppfd is recommended for flowering. It produces good light that helps them sprout and then build into nice strong plants. I also have zucchini that is full of blooms.

Others are on tripods and * attached to the plant stands. For the top of the cabinet, magnetic hooks work great, but for the lower shelf i used the wire /hook option it came with but had to cut part of it to rig it.

It has a dimmer switch on the cord. I like that it can be dimmed as i can dim it while the plants are young and then increase the light as they need it.

The light provides light and heat for my indoor pants. Not too much heat, perfect for 2x2 tent. Heat/warmth from the light is virtually no issue at all.

The bare aluminum back helpfully says do not touch when in operation. Put the unit down to inspect. There is perhaps a chance that i received a unit that was defective and shorting out.