Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Overview
- How are reviewers describing this item?
great, thin, good, little and down. - Our engine has profiled the reviewer patterns and has determined that there may be deception involved.
- Our engine has determined that the review content quality is low.
- Our engine has analyzed and discovered that 69.2% of the reviews are reliable.
- This product had a total of 69 reviews as of our last analysis date on Jul 20 2020.
Helpful InsightsBETA
Posted by a reviewer on Amazon
Air bubbles can be minimized or avoided entirely if applied with care and patience
Posted by a reviewer on Amazon
Abs sticks very well with 80°c open air bed using a roseart glue stick
Posted by a reviewer on Amazon
Very pleased and the tape can even be used a couple of times before needing to be replaced if you calibrate the plate well enough but assuming one print per tape you can get 100 6x12 prints from the roll
Posted by a reviewer on Amazon
I generally start the pull and get about 4 inches or so free from the roll attach it to one side and unroll the kaptop until it reaches across the bed then slowly squeegee it on the bed
Posted by a reviewer on Amazon
This stuff is a good deal 5 sheets of this at frys will cost you about ten bucks
Posted by a reviewer on Amazon
Its hard to get the parts free
Posted by a reviewer on Amazon
Great product realize that this is a very thin tape
Posted by a reviewer on Amazon
Works well for my 3d printer bed although it can be a bit tough to install on the glass
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found