Posted by a reviewer on Amazon

The reason i gave this product 4 stars is because the adhesive and plastic material tends to ripple at the ends between 4 and 6 uses in machines that use heated build plates and chambers

Posted by a reviewer on Amazon

Fix the ripple issue and ill give it a 5 star review and im sure most others with the same issue will too

Posted by a reviewer on Amazon

Excellent build surface for cold beds especially in conjunction with the use of an elmers glue stick to keep parts from curling

Posted by a reviewer on Amazon

The first piece was trash a few prints in i highly recommend exact z calibration before attempting to print

Posted by a reviewer on Amazon

If you print too deep in this you will have to destroy it to get your print off

Posted by a reviewer on Amazon

Now when there is a problem with the print i can be sure its not what i used to get it to stick to the bed

Posted by a reviewer on Amazon

Large parts definitely stick more than smaller ones but thats the case with anything you print on

Posted by a reviewer on Amazon

I had to use a hair dryer to heat up the object so that the spatula could get under it