Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found
Highlights
Quality
I usually smooth the bubble as best i can and wind up with a little wrinkle a defect which does not noticeably impact the quali... Read More
This was recommended as something to get with the xyzprinting da vinci jr
Overall i am super satisfied with the quality of this product especially given amount of bed protectors i received for the price
If you want to read a deliverytotrash analysis of my experience with the product i direct your attention to the wall of text below
Packaging/appearance
Because the sheet is so thin you need to be very careful when using a scraper to pry your finished prints from the bed otherwis... Read More
Competitiveness
I really didnt like it at first but its actuall not bad
Yes they are thinner in the item title but they will get the job done at 110th of the cost
Overview
- How are reviewers describing this item?
thin, smooth, first, surface and enough. - Our engine has profiled the reviewer patterns and has determined that there is minimal deception involved.
- Our engine has discovered that over 90% high quality reviews are present.
- This product had a total of 47 reviews as of our last analysis date on Apr 10 2021.
Helpful InsightsBETA
Posted by a reviewer on Amazon
The short version of this review is that the product provides a nice smooth surface for your prints but is a bit flimsy and the bubbles can be tricky to deal with
Posted by a reviewer on Amazon
The sheets are of course very thin while i dont have a measuring tool fine enough to verify the advertised 60 micron thickness it certainly cant be far off
Posted by a reviewer on Amazon
As another reviewer mentioned applying the sheet is much like applying a phone screen protector its very thin and very sticky so you need to be careful not to let it stick to itself too bad
Posted by a reviewer on Amazon
As a print surface i found it to be lacking adhesion on its own as my first small flat test prints were quite warped
Posted by a reviewer on Amazon
I say almost because there was one print that was very large almost used my entire build area and the warping was able to peel the sheet away from the print bed
Posted by a reviewer on Amazon
That has only happened once and it only failed for about an inch on one side of the build so i didnt lose the whole print as a result
Posted by a reviewer on Amazon
It was not the first print id done on that sheet so it could be that rather than that sheet being bad it was merely stressed by prior prints
Posted by a reviewer on Amazon
Like i said this has only happened once out of 40 prints so im willing to call it a fluke
Review Count History
Price History
Ask Fakespot Chat questions about this productAlpha
Add detailed feedback
Message
Loading suggested questions
Suggested Questions
Suggested Questions
No suggested questions were found